Joinery Archives - Page 4 of 299

How best to attach a massive table leg to top?
October 8, 2023

I have a 120cm x 70 cm by 4cm thick coffee table top, and want to attach two massive 35cm x 50cm x 8cm legs underneath. See picture.What would be…
Attaching outside rails and kickers on lowboy – question
September 5, 2023

I am making the Queen Anne lowboy based on the plans and FWW article (FWW Nov/Dec 2008) by the late Philip Lowe. I am completing case construction it’s glued up and now…
Gluing Breadboard Ends at the Front
August 9, 2023

I'm making a desk about 52" long by 28" wide. I'm going to use a breadboard end on the top. I made a table with breadboard ends years ago and…
unclear about how to proceed
July 14, 2023

Im building a Tansu cabinet from Mike Peckovich's book. Things are coming along slowly but surely. The (instructions) state that the runners run perpendicular to the grain of the case…
Finger joint cuts with longer wood boards
July 7, 2023

I am making a square end table with four 33” x 3” x 3/4”aprons connected by 3/4” finger joints at each corner. Previously, on small boxes I had mounted my…
Tabletop followup Q
July 4, 2023

Grettings All and Happy Independence Day! You may recall my recent post about adding breadboard ends to stretch a tabletop, this Q is for the same project... In going through…
Adding breadboard ends to stretch a table
June 25, 2023

Hi all, I have been asked to add length to a 5/4, 3-board maple table 30"x 40" as it sits now. Target is 46-48". I'm thinking breadboards, but anything I…
Outdoor Shoebox – Advice for a novice
June 14, 2023

Hello, I am fairly new to woodworking, have done a couple of courses so am getting familiar with the basics. I have recently pulled up some old Merbau decking that I…
Crossgrain Joint
May 31, 2023

What is best way to join crossgrain joint approximately 10 inches long.
Table Leg Mortise and Tenon Intersection Necessary?
May 27, 2023

I have built several tables with intersecting mortises and tenons where I mitered the tenons in the leg/apron joint. In each case this was done to get the tenon length…

Page 4 of 299 Previous

UNLIMITED membership - Get access to it all

Start Free Trial Upgrade Membership

We hope you’ve enjoyed your free articles. To keep reading, become a member today.

Get complete site access to video workshops, digital plans library, online archive, and more, plus the print magazine.

Joinery Archives - Page 4 of 299

Get the latest from Fine Woodworking Magazine

#315-JAN/FEB 2025

#314-Tools & Shops 2025

#313-NOV/DEC 2024

#312-SEPT/OCT 2024

#311-JULY/AUG 2024

We hope you’ve enjoyed your free articles. To keep reading, become a member today.