Joinery Archives - Page 59 of 299

I`am laminating some stair treads out D.Fir, 3 peices ea 2 1/8 x 3 3/4. Yes beefy. Question is what is a good size spline and best glue to use. Plan at…

i'm making a sideboard and i want to use plywood for the bottom. i like the sliding dovetails that were used in a hutch i saw in ffw. in that…

I have just finished an extremely stressful glue-up and would like some advice. I used a different brand of biscuits and they seem to have been slightly thicker than my…

I've just built a room divider that has three levels of open shelves. I built the face frames first and then built the carcass to "match". I'd say it's about…

I'm designing blanket chests for a customer,  36"L x 18"D x 15"H. Mahogany primary wood.  Mitered corner joints, flat top with trim around, trim flush with bottom of carcass, solid…

I want to make book matched 8x11" panels from 3/4" curly maple stock. My plan is to split the stock on the bandsaw and somehow edge glue into panels. My…

Ok, my first post! Hopefully this is in the right area and whatnot. I'm looking to build a low table, with a top 10' long, 22" wide. I want the…

Check out this guy's finger joint making jig on YouTube. I have no idea how to build a jig like this but the results are impressive. http://www.youtube.com/watch?v=yuFHurrWswQ&NR=1 P.S. Scroll through…

How would you construct an inset drawer that had a frame and panel front?  - The drawer is a about 8 inches tall - I had been planing to use…

Is it good joinery practice to use floating tenons of a different species. I'm doing a maple framed table and have left over oak tenons from another project. Tom