Joinery Archives - Page 70 of 299

Well, I trimmed a tenon to fit a mortise that it didn't belong going into (right hole wrong tenon), and well it is loose.  For the life of me I…

can anyone share a good picture of an oblique scarf joint?

Here it is, I don't have any drawings on the computer to show. I am building a TV stand that goes in the corner. My customer wants the stand to…

Be vewy, vewy quiet...I'm making a wabbet. I'm working on the tool cabinet from a recent FWW (http://www.taunton.com/finewoodworking/FWNPDF/011188040.pdf). The front and back panels are let in to the frame by…

I am looking for a router bit to do 1-3/8" cope and stick for the interior doors of our home.  This design is similar to Rogue Valley's plank raised panel…

...I love hand-cut dovetails! My husband has been giving me $#!@ about running the saws while my kids are asleep, which happens to be the ONLY time I can escape…

Bob, How are you coming on those QA lower side panels? What did you decide with the pin holes? Any joy yet? Maybe a jpeg progress shot? I'm looking forward…

I am not sure what I am doing wrong - I am cutting tenons from 3/8" by 1 and 3/8 wide slats so I have a 1/4 by 1 and…

I am looking for reference material on how to make full blind dovetails. so far I haven't found anything that describes in detail how to do it. my own attempts…

My first big project; perhaps too ambitious, but I want to try it. I purchased plans for a Morris chair from FWW. The instructions tell me to use 1/8 inch…