New To Woodworking Archives

Table Saw Books
November 1, 2024

Hey there,I’m really new to wood working and looking for a book on table saws, any recommendations? I’m specifically looking for a book that covers safety, set up, and jigs.…
“Put Me In, Coach.” Frame and Panel Door
October 2, 2024

Never built a f&p door, but I'd consider myself something of an intermediate. (You may have seen my sapele table in the gallery of late.)One item on the winter list…
Arbor shaft and blade spins when trying to remove TS blade
March 13, 2024

I recently got a table saw and thought it’d be fun to put a dado blade on it. Install went smoothly. However when I’m trying to take it off the…
Straightening a chisel’s cutting edge
January 21, 2024

Hi guys,A couple of the new chisels I have received have slightly squint edges. To straighten them, would I just push the 'shortest' point of the cutting edge against the protrusion…
Advice for lapping the back of new chisels
January 8, 2024

Hi all, I have a new set of Narex Richter chisels which I am going to sharpen for the first time using a scary sharp system (float glass and lapping film).…
Request for recommendations for a good square for laying out joints.
January 4, 2024

Looking to buy a square for laying out joints in the near future to replace my very cheap combi square. Thinking of getting this 150mm/6" one:Starrett 10MH-150 Cast Iron Square Head…
Sliding Bevels/Bevel Gauges – What size?
January 2, 2024

Hi all, Looking to get all the essential handtools in the coming months.Looking at a fairly inexpensive sliding bevel with the locking mechnism at the base - I've read this is…
Will pine wood warp if used for a short tabletop?
October 31, 2023

Hi,We are planning to make 13 portable laptop-like tables for a community project. To keep cost down we plan to use pine wood. The tabletop will be approximately 42" long…
M&T v’s Loose Tenon Joints
October 14, 2023

Does a Mortise & Tenon joint have any advantage over a loose tenon joint in strength or durability? I can't find any real testing on this question so experience may…
Herringbone table lip
July 17, 2023

Hoping to get some wisdom. Built a cedar herringbone coffee table. Framed along the perimeter, angles slats make the top. One side has a small lip, as in the slats…

Page 1 of 57

UNLIMITED membership - Get access to it all

Start Free Trial Upgrade Membership

We hope you’ve enjoyed your free articles. To keep reading, become a member today.

Get complete site access to video workshops, digital plans library, online archive, and more, plus the print magazine.

New To Woodworking Archives

Get the latest from Fine Woodworking Magazine

#314-Tools & Shops 2025

#313-NOV/DEC 2024

#312-SEPT/OCT 2024

#311-JULY/AUG 2024

#310-MAY/JUN 2024

We hope you’ve enjoyed your free articles. To keep reading, become a member today.