Power Tools and Machinery Archives - Page 101 of 1208

Anyone had motor trouble with this model?  Motor, at start up,  clicks, rumbles then stops. Have to push overload button to restart. Had this problem when saw was new, but…

I know most of you will suggest not to go with the benchtop jointer.  I just bought the PC160JT -- same as the Delta JT160.  I read a lot before…

Generally speaking, when I buy a tool I research it and usually make a good decision.  I bought a Rikon 4X36 sanding station and this time.... I made a mistake.  The…

I am considering buying a compressor for "driving" such things as random orbital (hand held) sanders, power carvers, brad nailers, finish nailers (as in trim around the house), constructin nailers,…

Hi, I just picked up a 12" Jet BS on craigslist for pretty cheap.  It didn't come w/ a blade.  For general use (tapering, dovetails, etc), what blade (teeth, width,…

Hello all, I recently purchased one of these planers. I'm having trouble getting short, thin stock to feed through without getting stuck or sniping the ends. I'm thinking maybe I…

I unpacked this new planer and checked all of the settings. Seemed good to go so I ran some Ash through it for some Mission end tables I am building.The…

Hello. Interested in an adequate horsepower rating in a tablesaw  for custom cabinetry /furniture work.Will run 4/4ths, 8/4ths hardwoods...... 80 vs 20% over sheetgoods.I'll thank you now for your input.

I am looking to purchase a handheld planer surface the face and edge of rough cut boards.  I have a scrub and jack plane and they work- but the work…

I'm looking for a remote to turn my dust collector on and off that doesn't cost an arm and a leg.  Any suggestions?