Power Tools and Machinery Archives - Page 1119 of 1208

Preferred Bandsaw Blades?
December 19, 2002

I just bought a riser block for my Jet 14" bandsaw and purchased two Olson bandsaw blades for resawing some soft maple and boy was I disappointed. The 1/2" blade…
Finish Sanders
December 19, 2002

I believe my finish sander died last night. Sparks were flying and it got very loud. It may be a loose screw and/or the brushes..I'll see if I can replace…
ROUTER BITS
December 18, 2002

CONSIDERING BUYING RAIL & STILE BIT SET. QUESTION AS TO BUYING REVERSABLE SET OR JUST THE STANDARD SET AND WHY ARE THERE TWO STYLES.
Help cleaning tablesaw gearing
December 18, 2002

Help! I have a Powermatic 66 table saw about 10 Years old. The blade raising and lowering gearing has become covered with pitch, grease and sawdust and is very difficult…
Benchtop Table Saw
December 17, 2002

I have a 10 inch benchtop table saw and would like to know if it will operate safely with a dado blade. If so, what size dado blade should I…
220V bulb
December 17, 2002

I have a Jet 16 1/2 inch drill press with a 3/4 HP motor, recently purchased. It can be run on either 115 volts or 230 volts, but it has…
Hand toolparts
December 17, 2002

Can any one tell me where I can get brass thumb screws, & knurled brass fittings for making my own hand tools? Joseph, Los Angeles Calif. Edited 12/16/2002 11:11:57 PM…
Plane for Tenon Cheeks
December 17, 2002

Hi, Everytine I cut tenons I cut them a little big and end up fitting them with a Stanley no.90. I can use this on the shoulders as well. I'm…
General bench top Mortiser,
December 17, 2002

Just bought a General mortiser model#75-050MI. So far I've only used to Make a few test cuts,& it works Great! The 1/2" chisel bit set cut smoothly in Red Oak. I've read…
Cheezy durn starting capacitor!
December 16, 2002

It went out on my Delta 1200 cfm DC. 30 MFD, 250V. Customers waiting and it's sunday! GRRRR! I tried a 550MFD and it wouldn't work. Cheeziest starting capacitor I've…

Page 1119 of 1208 Previous

UNLIMITED membership - Get access to it all

Start Free Trial Upgrade Membership

We hope you’ve enjoyed your free articles. To keep reading, become a member today.

Get complete site access to video workshops, digital plans library, online archive, and more, plus the print magazine.

Power Tools and Machinery Archives - Page 1119 of 1208

Get the latest from Fine Woodworking Magazine

#315-JAN/FEB 2025

#314-Tools & Shops 2025

#313-NOV/DEC 2024

#312-SEPT/OCT 2024

#311-JULY/AUG 2024

We hope you’ve enjoyed your free articles. To keep reading, become a member today.