Power Tools and Machinery Archives - Page 1138 of 1208

Lost a tooth
October 28, 2002

While sawing a raised panel on a home made jig I brushed one of the screws with my carbide toothed table saw blade which broke one of the carbide tips…
Warped table saw blade?
October 27, 2002

I recently made a zero-clearance throat plate for my Delta table saw, but after I raised the blade through the blank, I noticed that the hole made by the saw…
Widebelt vs Drum Sander for the sm. shop
October 27, 2002

I'm looking at drum sanders vs. wide belt sanders: New Bridgewood 25" (single phase 10 horse), used AEM 24" (three phase 30 horse - needing phase converter) or Woodmaster/Performax drum…
The Best Lathe for $2000
October 26, 2002

I'm looking for a multi purpose lathe for bowls and spindle turning, outboard turning would be good. $2000 or less. Does anyone have on opinion on the best buy? I've…
Making Infeed and Outfeed Parallel
October 26, 2002

Does anyone out there no how to make the infeed and outfeed tables on my Jet 6inch Jointer Parallel to one another? I have the Jet JJ-6CSX Jointer. I can…
Right vs Left Tilt Unisaw
October 26, 2002

I would like to purchase the Unisaw but cant decide betwee the two. I like the safety and direction of the LT. I am concerned that the safety would be…
Screaming band saw
October 26, 2002

There has been several discussions on band saws so I'll chime right in with something I have been experiencing with my 14" Jet: I have been reswaing with a carbide…
Router combos
October 26, 2002

Has anyone tried the fixed/plunge router combos out there? Especially the PC? Sounds like it might be a good upgrade for me over my yr-old Craftsman fixed based (and I…
Upcut spiral slow burn
October 26, 2002

Why would my new carbide 1/4" upcut spiral bit have so much difficulty compared to the two flute carbide straight bit I was using? I could barely force the 3/4"…
Nova DVR 3000 Lathe
October 25, 2002

Does anyone know or heard about how good the Nova 3000 DVR lathe is. Sold only at Woodcraft I think. Direct drive motor, runs on any voltage, no wiring coils just…

Page 1138 of 1208 Previous

UNLIMITED membership - Get access to it all

Start Free Trial Upgrade Membership

We hope you’ve enjoyed your free articles. To keep reading, become a member today.

Get complete site access to video workshops, digital plans library, online archive, and more, plus the print magazine.

Power Tools and Machinery Archives - Page 1138 of 1208

Get the latest from Fine Woodworking Magazine

#315-JAN/FEB 2025

#314-Tools & Shops 2025

#313-NOV/DEC 2024

#312-SEPT/OCT 2024

#311-JULY/AUG 2024

We hope you’ve enjoyed your free articles. To keep reading, become a member today.