Power Tools and Machinery Archives - Page 18 of 1207

Greetings all.An elderly friend has offered me an old 20"  Delta bandsaw that's been sitting unused in the back of his shop for some unknown number of years. He knew…

Just put a 3/16” 4tpi blade on my Rikon bandsaw. The problem is that when I get the tension right (or what feels right), and then turn the wheel to…

Has anyone had experience or information on Volpato woodworking machinery? I have a 5hp 240V sander that I inherited. Volpato is out of Italy and this was made in 1987.…

I was working in my shop yesterday dimensioning Poplar into rails and stiles on my SawStop.  I noticed that I had a number of bandages on my fingers and thumb…

hopefully this is the correct place to list the sawhelper for sale  it is complete, with the stop, with one seven feet leg and one four feet leg.  asking $350.00…

Just put together my new Rikon 14” bandsaw (10-326). But after a closer inspection, the blade is touching the side of the table insert. I can’t figure out how to…

While adjusting the tracking, an expensive 115" carbide tipped resaw blade broke (not on the weld).Would to start going with cheaper, more easily replaceable blades.  Any good recommendations for Laguna…

Hi all. Looking for some advice. Planning to buy a 6" jointer. Found two jointers locally and I am trying to decide between the two. Both would require clean up, probably…

My friend who has a sawstop PCS said he had to repair his saw.  He said a part (capacitor maybe?) failed because he often left the master switch in the…

Looking for some recommendations. My dust collector fails to completely start up. Motor starts and gets just about there before the breaker on it kicks. This has happened before and replacing…