Power Tools and Machinery Archives - Page 26 of 1207

I am just a woodworker hobbyist. Mostly make tables from oak, ash or walnut.Anyway I went to use my 13" Craftsman planer today and the height would not adjust. Checked…

I used this planer today on (2) 6"x 18" x 3/4 birch boards and it created a groove about 2" in on each peice all the way across each board.The…

I’ve been spending some time recently checking the setup on some of my machines. When checking the the miter gauge on my table saw I’ve run into an issue. I’ve…

GreetingsWhen I see "intro to table saw"-type instructional content on the web, Ch. 1 is always about safety (as it should be).  At some point though, the use of feather…

I have been using Hammer machinery for almost a decade - Tablesaw, Bandsaw and Jointer thicknesser, superb macinery.My K3 tablesaw started seriously vibrarting ten seconds after switching on the machine.…

I've never used router template guides before and I'm wondering about the descriptions Bosch uses identifying various guides contained in the kit.  For example:"RA1103 -- Template guide for small dovetail…

I have a woodtek sp-20 from 1993. I'm trying to get a spiral cutterhead for it and I'm having trouble finding one. I got to looking at the grizzly g0455…

I have a grizzly dust collector with a 4-in port and I wanted to split it so that I could use the bottom that goes to the table saw and…

Oaktrim gave a suggestion as to how to align the blade but I don’t understand. “Opposite to blade...” where are you Oaktrim I need your help

Hello friends,I found these two machines for sale and I was hoping to find help putting a fair price on them. they're in working condition but need some restoration with…