Power Tools and Machinery Archives - Page 62 of 1208

Hi, I picked up an old Delta 37-301 jointer really cheap, but its missing a few things. First, I need to find a crank wheel for the outfeed side. Sec…

Hello all, I recently got a new bandsaw–a Grizzly G0457–based on its great review in Fine Woodworking Magazine (http://www.grizzly.com/products/14-2-HP-Deluxe-Bandsaw/G0457). I set up the bandsaw and have worked with it a…

I have a Jet 18 " QT version.  But this question would apply to any saw using roller bears.  Whan I adjust the 2 sets of side bearings I can…

Hello,   I am restoring an old 36" band saw that has babbit bearings on the arbor shaft.  There is a trough above the bearings with holes that allow lubricant…

I have a General International 10 inch table saw, model 50-200R, 10 months old.  The raise and lowering mechanism worked like silk when new, and still does, however when the…

What are  your saw blades? And where do you purchase them?

Gentlemen, I am trying to organize my woodshop into a small garage and to do this I need to shorten the rails on my tablesaw. I currently have a shop…

About 10 years ago I bought an 8' long heat element for bending postforming grade laminate aroun a 2" radius.  It looked just like a long floresent light except there…

I have a General 50-200r tablesaw - with a General T-Fence -  I set the mitre slot to the blade and the fence to the mitre slot weithin .002in. if…

Might just be a "decent deal"?     Came with it's own metal case, no less.    Open up the well worn box, and found a SKIL saw.   Not just any Skil saw…