Power Tools and Machinery Archives - Page 86 of 1208

Table saw starting problem running on a generator
May 2, 2011

I recently replaced my 30+ year old Beaver table saw which ran flawlessly on my Honda generator; always started instantly. The motor was the original Franklin 1HP 110V. The new…
Milwaukee 5616-24
May 1, 2011

I've just bought a Milwaukee 5616-24 router kit and am looking for an edge guide for it. Milwaukee sells an edge guide for it but I was wondering if anyone…
Moidel 66 rebuild tips?
April 30, 2011

Rebuilding an old Powermatic 66. Everything is looking good so far, but I just can't get the nut free to remove the arbor and replace the bearings. And tips, tricks…
ADJUSTMENTS FOR THE DEWALT DW735 THICKNESS PLANER
April 30, 2011

I am fine-tuning my Dewalt 735 thickness planer so that I can build a credenza for a friend, made almost entirely of highly figured curly maple (“luthier quality”). Obviously, the…
Oliver 166BD 12″ Jointer “Knife Grinding Attachment”
April 29, 2011

Hello out there....yes, I'm a newbie on this site so go easy on me! Hoping this site is easier to navigate than what I just experienced trying to post on…
band saw blade maintance/cleaning
April 29, 2011

My band saw blade does not cut like it use to - it needs cleanings - any suggestions. I am sure this question has been asked and answer, which I…
Drill Press Run Out
April 25, 2011

I have a delta bench-top drill press. I am having trouble with the bits wobbeling. Everything above the bit is rock solid and steady. Any suggestions about cause and what…
Unwanted slightly curved cuts on cabinet saw
April 25, 2011

I'm a relatively new wood worker who has "dialed-in" my table saw to very close tolerances, or so I believe. I am getting slightly curved cuts when ripping. The cuts…
Eurekazone guides
April 22, 2011

Have been think of getting Festool or Dewalt CS and guide rails. Saw something about Eurekazone and looked at website. Looks good but requires a lot of setup for each…
update to beaver jointer
April 21, 2011

Took the plunge and picked up the beaver 3800 jointer today--cost was a hundred bucks so I figured I couldn't go too wrong. Got it home and had to re-wire…

Page 86 of 1208 Previous

1
84
85
86
87
88
1208

UNLIMITED membership - Get access to it all

Start Free Trial Upgrade Membership

We hope you’ve enjoyed your free articles. To keep reading, become a member today.

Get complete site access to video workshops, digital plans library, online archive, and more, plus the print magazine.

Power Tools and Machinery Archives - Page 86 of 1208

Get the latest from Fine Woodworking Magazine

#315-JAN/FEB 2025

#314-Tools & Shops 2025

#313-NOV/DEC 2024

#312-SEPT/OCT 2024

#311-JULY/AUG 2024

We hope you’ve enjoyed your free articles. To keep reading, become a member today.