Turning and Carving Archives - Page 30 of 45

Finish for Cherry Cabinets
December 1, 2007

Hello, Starting a cherry kitchen cabinet project in the near future. Looking for finish recommendations. Ideally want to use oil for an "in the wood finish". I would also use…
Refernce book for baluster turnings
November 30, 2007

Hello, I was wondering if anyone here could recommend a design reference book that covered traditional/contemporary baluster and newel post designs. I'm not looking for a how-to turning book, rather…
wooden sculpture and bone
November 17, 2007

An artist from Kentucky did this carving in wood and covered it with bone. His name is Frank House, brother to Hershel House a well known kentucky longrifle builder. Frank…
Turning Tools Sharpness
November 9, 2007

Hello All ! I do a little turning now and again, the problem I have is the tools don't stay sharp very long. Is it because they are made of…
Chuck comparison
November 5, 2007

Anyone know the key differences between the One Way chuck and the Nova chuck?
bench grinder
October 30, 2007

what bench grinder is best for sharpening lathe tools
CLAMPING ON LATHE
October 29, 2007

have a barracuda chuck for lathe the flat jaws have rubber covered bolts for clamping can you replace rubber or replace boltes where do you get them …
Gouges are catching I need help
October 28, 2007

I can not figure out why my gouge and Skew is catching so much ? My tools are sharp I'm holding my gouges right but there catching. Any Ideas I…
Turning pulls needed
October 25, 2007

Hello, I am building a piece of furniture and would like to have the door pulls made from the same wood. I need 2 each of 2 different types (4…
Low Cost Chucks
October 23, 2007

Hi anyone have any experience with some of the LOW COST CHUCKS, like the ones from Grizzly- Penn State nova etc.? Looking for my 1st Chuck. I want something decent…

Page 30 of 45 Previous

UNLIMITED membership - Get access to it all

Start Free Trial Upgrade Membership

We hope you’ve enjoyed your free articles. To keep reading, become a member today.

Get complete site access to video workshops, digital plans library, online archive, and more, plus the print magazine.

Turning and Carving Archives - Page 30 of 45

Get the latest from Fine Woodworking Magazine

#315-JAN/FEB 2025

#314-Tools & Shops 2025

#313-NOV/DEC 2024

#312-SEPT/OCT 2024

#311-JULY/AUG 2024

We hope you’ve enjoyed your free articles. To keep reading, become a member today.