Hollow-Chisel Mortiser Speeds up Half-Blind Dovetails

For me the most difficult stage of half-blind dovetails is removing the wood between the pins, especially when working with tough hardwoods. After scribing the baseline and making the partial sawcuts that define the sides of the pins, I use my hollow-chisel mortiser to remove most of the waste at the back of each socket, leaving a clean shoulder at the baseline. Set the depth as needed, and select a chisel size (usually 1/2 in.) that will stay just inside the sawcuts.

With most of the waste gone and the baseline established, paring and chopping out the remaining wood is fast and easy, and I get a nice, tight fit every time.

Click here to enlarge the illustration above.

—RICHARD GALIK, San Antonio, Texas

Illustrations by Dan Thornton
From Fine Woodworking issue #284

Fine Woodworking Recommended Products

Suizan Japanese Pull Saw

A versatile saw that can be used for anything from kumiko to dovetails. Mike Pekovich recommends them as a woodworker's first handsaw.

Buy at Amazon

Freud Super Dado Saw Blade Set 8" x 5/8" Bore

Leaves a dado with a flat bottom and even performs excellent on plywood and melamine.

Buy at Woodcraft

Veritas Precision Square

This precision square is incredibly versatile, from checking squareness to dialing in machine setups.

Buy at Lee Valley