This shop is similar to the shop that I have, with a little better layout.  However, it has a few additions that I would like to add to mine.  It allows the material to enter from the 8′ garage door to be stored or cut, planed, joined or shaped into the pieces needed for the project.  As you work around the shop in an upside down U pattern, you begin to use tooling to get the material to the more finished look.  Once the project has been completed and ready for stain, paint or other finishes, you finally come to the finish room.  I would like to have an exhaust fan built into the wall of the room, but that item wasn’t offered.  After the final touches are completed, there is a sliding or double set of doors to allow the finished project to be loaded from the finish room.  This way you do not have to work it through the workshop with a chance of bumping into a new project that is scattered from table to table.  Finally, I have the air compressor inside a room, that would have an exterior vent and a temperature controled exhaust fan, to keep the sound down.  Hope you like it.