Gallery
Southwest style desk
May 09, 2017
Like many projects, the trickiest part of this build was the drawers. I wanted vertical grain that matched from the bottom drawer face through the top drawer. I glued up two boards to get the width I needed, then crosscut a 1/8″ piece that I used as the top edge veneer of the top drawer. Next, I crosscut a piece the height of the drawer which I resawed to make the front and back veneered faces of the drawer. Then cut another 1/8″ piece for the bottom, another for the top of the next drawer, etc.
Finished with General Finishes Arm R Seal satin.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
-
-
-
-
It took me a few tries to figure out how to make the pulls, but I was happy with the end results.
-
Log in or create an account to post a comment.
Sign up Log in