Shop Tips - Page 147 of 164

Circle Guide for the Router
October 25, 2005

This fixture for routing circles has several advantages over commercial circle guides: it's cheaper, it cuts circles smaller than the router base and it allows repeat set-ups to precise radii…
Pin Router Attachment
October 25, 2005

By bolting a simple router arm and an auxiliary table to my drill press, I can convert it to a pin router. This lets me take advantage of the drill…
Thickness-Sander Attachment for Lathe
October 25, 2005

The sketch above shows the thickness-sander lathe attachment I made to sand dulcimer tops and sides. The design is similar to the sanders shown in Fine Woodworking #21, p. 50,…
Enlarging Flute Bores Revisited
October 25, 2005

Here's my variation on the method Vasco Pini uses to enlarge the bores of flutes (Fine Woodworking #35, p. 16). First drill a pilot hole through the flute blank with…
Chamfering Tambour Strips
October 25, 2005

Here's a jig I developed to safely chamfer the edges of narrow strips, such as tambours. It consists of a straight piece of scrap as long as the strips and…
Dressing Thin Stock
October 25, 2005

This jig allows you to dress stock to thinner than 1/8 in. on a conventional thickness planer. Without it the thin workpiece will vibrate and often splinter on the ends.…
Hand-Feed for the Parks Planer
October 25, 2005

Here's a simple way to get an infinitely variable feed rate on a Parks Model 97 thickness planer, without altering any part of the machine. Simply install a hand crank…
Scissor-Jack Fence
October 25, 2005

After years of enduring the inconvenience of removing and resetting numerous small bolts to adjust the fence on my router table, I made an adjustable fence that makes the whole…
Miter-Gauge Setting Jig
October 25, 2005

Some tablesaw miter-gauge settings are the result of tedious trial-and-error, cut-and-fit procedures. Here's how to preserve that hard-won setting for future use. Cut two 1x2 strips about 1 ft. long.…
Safe Ripping on the Radial-Arm Saw
October 25, 2005

While building an architectural model requiring extremely small pieces, I discovered this safe, accurate way to rip short or small stock on my radial-arm saw. The key is a substitute…

Page 147 of 164 Previous

UNLIMITED membership - Get access to it all

Start Free Trial Upgrade Membership

We hope you’ve enjoyed your free articles. To keep reading, become a member today.

Get complete site access to video workshops, digital plans library, online archive, and more, plus the print magazine.

Shop Tips - Page 147 of 164

Get the latest from Fine Woodworking Magazine

#314-Tools & Shops 2025

#313-NOV/DEC 2024

#312-SEPT/OCT 2024

#311-JULY/AUG 2024

#310-MAY/JUN 2024

We hope you’ve enjoyed your free articles. To keep reading, become a member today.