Shop Tips - Page 150 of 166

Scissor-Jack Fence
October 25, 2005

After years of enduring the inconvenience of removing and resetting numerous small bolts to adjust the fence on my router table, I made an adjustable fence that makes the whole…
Miter-Gauge Setting Jig
October 25, 2005

Some tablesaw miter-gauge settings are the result of tedious trial-and-error, cut-and-fit procedures. Here's how to preserve that hard-won setting for future use. Cut two 1x2 strips about 1 ft. long.…
Safe Ripping on the Radial-Arm Saw
October 25, 2005

While building an architectural model requiring extremely small pieces, I discovered this safe, accurate way to rip short or small stock on my radial-arm saw. The key is a substitute…
Sliding Dovetail Fixture
October 25, 2005

While attempting to rout long sliding dovetails on the end of shelving joints, I found it impossible to keep the over-wide and long shelves perpendicular to my router table. Here…
Cutting Flutes on Curved Turnings
October 25, 2005

For cutting reeds and flutes in curved and tapered turnings, I use a cutter mounted in a drill press, and a special indexing jig to hold the workpiece. Although making…
Drilling Compound Angles
October 25, 2005

Here's a simple method for drilling accurately through irregular workpieces, or for drilling tricky compound angles and having the hole exit where you want it. First clamp a board to…
Guide Blocks for Accurate Hand-Planing
October 25, 2005

Because I don't own a jointer, I rely on my bench planes for truing up my lumber. To maintain a consistent angle, I cut guide blocks from scrap pieces of…
Improved Horizontal Mortiser
October 25, 2005

This horizontal mortising router jig is a more versatile adaptation of G.R. Livingston's (Fine Woodworking #22). The jig can be clamped in a vise, but is fully portable and could…
Router-Table Fence for Edging Discs
October 25, 2005

I developed the fence shown above to shape the edges of round rings, such as clock bezels, on the router table. The fence can shape both outside and inside edges…
Three-Jaw Overshoes for Bowlturning
October 25, 2005

Like many avid woodturners, I use a three-jaw chuck for bowlturning and other faceplate work. With it you can avoid screw holes in the bottom of the bowl or skip…

Page 150 of 166 Previous

UNLIMITED membership - Get access to it all

Start Free Trial

We hope you’ve enjoyed your free articles. To keep reading, become a member today.

Get complete site access to video workshops, digital plans library, online archive, and more, plus the print magazine.

Shop Tips - Page 150 of 166

Get the latest from Fine Woodworking Magazine

#316-MAR/APR 2025

#315-JAN/FEB 2025

#314-Tools & Shops 2025

#313-NOV/DEC 2024

#312-SEPT/OCT 2024

We hope you’ve enjoyed your free articles. To keep reading, become a member today.