When building a large picture frame for a friend, I needed to add keys to the miters for strength. The problem was that the frame was more than 60 in. long on each side. In the past, I had always used a simple cradle jig on the tablesaw to hold the frame upright while cutting the slot. But this frame was much too large for that. My solution was to use this simple fixture and a bottom-bearing-guided, slot-cutting bit in a router.

To make the jig, cut two plywood pieces at 45° and attach them to a 1/4-in.-thick plywood base so they meet at 90°. The fences should be the thickness of or thicker than the frame, and the base should be sized so that it supports the frame sufficiently. To use, clamp the frame into the notch and run the bearing-guided router down the fixture to cut the key slot in the corner of the frame. You’ll need to make test cuts to get the slot height just right.

Drawings by Jim Richey

Drawings by Jim Richey

Fine Woodworking Recommended Products

Hedgehog featherboards

The Hedgehog's unique spiral shape and single knob make it easy to set up and fast to adjust.

Buy at Amazon

MicroJig Matchfit dovetail clamps

These unique clamps have angled tips that hold templates and fences in place without getting in the way.

Buy at Amazon

Incra Miter 1000HD

One of many extremely accurate Incra miter gauges, this model offers 180-degree adjustment to 1/10 of a degree, and a long, straight fence with a telescoping stop system.

Buy at Amazon