Clamps - Page 6 of 16

Hand-Screw Vise Holds Odd Pieces on Drill Press
February 7, 2013

To make a versatile drill-press vise for round or irregular workpieces, start with an inexpensive 10-in. wood hand screw. Cut a 110° notch out of each jaw with a bandsaw.…
Portable Vise is Great for Dovetailing
December 6, 2012

I made this fixture for routing away the waste between pins in half-blind dovetails, but it also works well for tasks like sawing the tails or routing a dovetail socket…
Moving the Craft Forward
October 25, 2012

Moving the Craft Forward
Benchcrafted- Glide Leg Vise
February 9, 2012

Bechcrafted's Glide leg vise makes holding workpieces on the bench more solid—there is none of the flex so common in traditional wooden tail vises.
Benchcrafted- Tail Vise
February 9, 2012

Benchcrafted's tail vise can be built up in a left- or right-handed version and can be retrofitted to most benches.
Garage Shop
December 17, 2011

A great shop layout for a double car garage
Bessey- Auto-Adjust Toggle Clamp
December 8, 2011

These clamps adjust automatically to accommodate a wide range of thicknesses, while clamping pressure stays the same
Bessey- Toggle Clamp
September 29, 2011

Toggle Clamp
Steam bending simplified
August 20, 2010

Recently, I was making new counters for my kitchen and ran into a problem. The cherry edging wouldn't bend around two tight curves at one end, so off I went…
Lie-Nielsen Chain Drive Vise
July 29, 2010

With heavy-duty acme screws mounted in massive steel hardware, Lie-Nielsen’s front-mounted vise is built for a lifetime of service. It holds wide and narrow stock equally well.

Page 6 of 16 Previous

1
4
5
6
7
8
16

Next

UNLIMITED membership - Get access to it all

Start Free Trial Upgrade Membership

We hope you’ve enjoyed your free articles. To keep reading, become a member today.

Get complete site access to video workshops, digital plans library, online archive, and more, plus the print magazine.