Router Jigs - Page 15 of 21

Router Circle-Cutting Jig
October 25, 2005

This inexpensive but accurate circle-cutting jig is made with two 18-in.-long rods that fit the guide holes in your router. Cut threads on one end of each rod and, using…
Combination Router-Table Bit Guard and Stops
October 25, 2005

I added two 3-in.-wide, 15-in.-long pieces of hardwood to the fence of my router table. Each piece is mitered on the end closest to the bit and attaches to the…
Scissor Jack Router Lift
October 25, 2005

After looking through catalogs and saving my pennies, I finally located the perfect plunge router for my router table or so I thought. After mounting it in the table, it…
Combination Horizontal and Vertical Router Table
October 25, 2005

I made this combination router table so that I could quickly switch the tool from the traditional vertical position to a horizontal position for making raised panels and sliding dovetails.…
Fluting Fixture
October 25, 2005

Fluting is an operation that is so seldom required that it does not warrant buying special equipment for the purpose. So when I needed to flute some short columns, I…
Router Circle-Cutting Simplified
October 25, 2005

Although I've seen dozens of methods for routing circles over forty years of woodworking, the method I stumbled on early is still the least complicated and quickest I've seen. Two…
Cutting Pocket Holes on a Router Table
October 25, 2005

Not too long ago, I went down to the tool store on a wishing trip. I saw a pocket cutter, which I really don't need for the five or six…
Jointing Boards With the Router
October 25, 2005

If you don't have a jointer, this easy-to-use jig lets you joint boards with a router. The method depends on a simple aluminum-angle-edged guide board and a commercial-grade flush-trimming bit.…
Routing the Edges of Odd-Shaped Pieces
October 25, 2005

Shaping edges on small pieces with a router is always ticklish. I was recently faced with this problem when I needed to round over edges on some one-half scale tapered…
Fluting Jig Guides Router
October 25, 2005

Fluting in flat surfaces adds grace to fireplace surrounds, doorway casings and the like. This router jig simplifies the process. Start by building a guide carriage with two parts: a…

Page 15 of 21 Previous

UNLIMITED membership - Get access to it all

Start Free Trial Upgrade Membership

We hope you’ve enjoyed your free articles. To keep reading, become a member today.

Get complete site access to video workshops, digital plans library, online archive, and more, plus the print magazine.

Router Jigs - Page 15 of 21

Get the latest from Fine Woodworking Magazine

#314-Tools & Shops 2025

#313-NOV/DEC 2024

#312-SEPT/OCT 2024

#311-JULY/AUG 2024

#310-MAY/JUN 2024

We hope you’ve enjoyed your free articles. To keep reading, become a member today.