Steam Bending - Page 10 of 13

Mountain Dulcimer, Gavels, Boxes
December 30, 2008

The Mountain Dulcimer for my Mom is bookmatched cherry top and bottom, with a walnut fingerboard. The gavels were turned from Texas Mesquite my Dad brought up for me and…
Making a Bail for a Shaker Chip Box
December 23, 2008

In starting the design for a Shaker Chip Box, I thought how easy it looked - but soon was surprised by the complexity of the bent handle or Bail. This…
5″ Round Nantucket Lightship Basket
December 16, 2008

For Laura... A five-inch round Nantucket Lightship basket using (mostly) traditional materials and methods. The base, handle, rim-halves and staves are of red oak, the weavers are 1.50 mm...
Wall light for my wife.
December 13, 2008

I basically adapted an Asian table lamp design that I ran across to a wall light. I changed the dimensions and some of the detail. I don't remember where I…
“for lovers only rocking bench”
December 11, 2008

"For my brother" made of white birch,mortis and tenon wedge construction,2 oil paintings (copied from 2 swedish paintings done in the 1640 ,24k gold guilded arrow head and other parts…
Dale’s bar
December 1, 2008

Bar top is old growth birch from lake superior - resawn and astheticly matched on a one piece 1" baltic birch plywood subtrate. In lay is same material with crushed rock…
Making a Tapered Bend
November 20, 2008

Following my last post, I felt somewhat uncomfortable about taking a short-cut with the Back Post. Rather than executing a bowed bend for the upper section of the Back Post,…
More on Ladder Back Chair Back Slats
November 12, 2008

Recently I have been modeling an 18th C. Ladder Back Arm Chair (Connecticut, Circa 1740). Here is a picture of the modeling status so far. Again I faced the creation of Back…
Writing arm windsor chair
November 7, 2008

Pine seat, maple turnings, oak spindles, arm and crest rail. Oil over milkpaint finish.
Fantail Bench
November 5, 2008

This was an interesting project in the restoration of a yacht from 1930. Slight modifications were made from the original blueprint. All exposed parts are made entirely from teak. The...

Page 10 of 13 Previous

UNLIMITED membership - Get access to it all

Start Free Trial Upgrade Membership

We hope you’ve enjoyed your free articles. To keep reading, become a member today.

Get complete site access to video workshops, digital plans library, online archive, and more, plus the print magazine.

Steam Bending - Page 10 of 13

Get the latest from Fine Woodworking Magazine

#314-Tools & Shops 2025

#313-NOV/DEC 2024

#312-SEPT/OCT 2024

#311-JULY/AUG 2024

#310-MAY/JUN 2024

We hope you’ve enjoyed your free articles. To keep reading, become a member today.