I’ve seen complicated jigs for flattening a wide board in a thickness planer, but I have a simpler method that uses rails glued to the boards. I use basswood for the rails because it’s inexpensive and soft. First, cut the board into the shortest length possible and joint or handplane the edges straight. Position the board cupped side up on a flat work surface. Insert wedges at each end near the corners until the board is lifted off the table with between 1/16 in. and 1/8 in. of clearance and doesn’t rock.

Now glue the 3/4-in.-thick rails to the board’s edge so their bottoms rest flat on the work table. After the glue has cured, remove all clamps and double-check that the side rails are still sitting flat on the work table. Remove any high spots with a handplane.

Click to enlarge

Now run it through the planer. Once the concave section is flat, flip the board and plane the other side. Then rip off the side rails.

Drawings by Jim Richey

Drawings by Jim Richey

Fine Woodworking Recommended Products

Incra Miter 1000HD

One of many extremely accurate Incra miter gauges, this model offers 180-degree adjustment to 1/10 of a degree, and a long, straight fence with a telescoping stop system.

Buy at Amazon

Hedgehog featherboards

The Hedgehog's unique spiral shape and single knob make it easy to set up and fast to adjust.

Buy at Amazon

Festool DF 500 Q-Set Domino Joiner

This joinery machine revolutionized woodworking for so many. There is no easier way to get mortise and tenon joints—but it comes at a cost.

Buy at Amazon